Dolmar EB166 Manual De Instrucciones Original página 7

All manuals and user guides at all-guides.com
• Waste electrical products should
not be disposed of with household
waste.
facilities exist. Check with your local
authority or retailer for recycling
advice.
• Double insulation
SAFETY WARNINGS
1. Important safety instruction
• Please read all of the safety and operating instructions
carefully before using this product. Please pay particular
attention to all sections of this operator manual that
carry warning symbols and notices. Failure to follow the
warnings and instructions may result in electric shock,
burn, and/or serious injury.
• This tool is intended for blowing and mulching. Never
use the tool other than its intended use, such as inflat-
ing balloons.
• The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
• Save all warning and instructions for future reference.
2. Training
• Read the instructions carefully. Be familiar with the
controls and the proper use of the tool.
• Never allow children, persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge or people unfamiliar with these instructions
to use the blower. Local regulations may restrict the age
of the operator.
• Never operate the tool while people, especially children,
or pets are nearby.
• The operator or user is responsible for accidents or
hazards occurring to other people or their property.
3. Preparation
• While operating the tool, always wear substantial
footwear and long trousers.
• Dress properly - Do not wear loose clothing or jewel-
lery. They can be caught in moving parts. Use of sturdy
gloves and substantial footwear is recommended when
working outdoors.
• Wear protective hair covering to contain long hair. Wear
protective goggles while operating.
• To prevent dust irritation the wearing of a face mask is
recommended.
• Before using, check the supply and extension cord for
signs of damage and aging. Do not use the tool if the
cord is damaged or worn.
• Never operate the tool with defective guards or shields,
or without safety devices, for example collection bag in
place.
• Only use a weather proof extension cable correctly
rated to your machine.
Please recycle where
4. Operation
• Always direct the cable to the rear away from the tool.
• If the cord becomes damaged during use, disconnect
the cord from the supply immediately. DO NOT TOUCH
THE CORD BEFORE DISCONNECTING FROM THE
SUPPLY. Do not use the tool if the cord is damaged
or worn.
• Do not carry the tool by the cable.
• Avoid Dangerous Environment - Don't use the tool in
damp or wet locations.
• Disconnect the tool from the mains supply:
– whenever you leave the tool.
– before clearing a blockage.
– before checking, cleaning or working on the tool.
• Switch off the tool immediately, disconnect the tool
from the mains supply and inspect for obstructions or
damage to the unit:
– after striking a foreign object.
– if the tool starts to vibrate abnormally.
• Operate the tool only in daylight or in good artificial light.
• Do not overreach and keep your balance at all times.
• Always be sure of your footing on slopes.
• Walk, never run.
• Keep all cooling air inlets clear of debris.
• Never blow debris in the direction of bystanders.
• The tool should be supplied via a residual device with a
tripping current of not more than 30 mA.
5. Maintenance and storage
• Before servicing, inspection, or storage, or to change an
accessory, switch off the tool, remove the plug from the
mains and wait until all moving parts stop completely.
Cool down the tool before making any inspections,
adjustments, etc. Maintain the blower with care and
keep it clean.
• Keep all nuts, bolts and screw tight to be sure the tool is
in safe working condition.
• Check the tool frequently for wear or deterioration.
• Replace worn or damaged parts.
• Use only genuine replacement parts and accessories.
• Store Idle Tools Indoors - When not in use, tools should
be stored indoors in dry, and high or locked-up place
- out of reach of children.
6. Additional safety rules for blower / mulcher
• Always wear adequate protective clothing when
operating the tool to avoid injuries to face, eyes, hands,
feet, head or hearing. Use safety glasses or a face
shield, high boots or sturdy shoes, long trousers, work
gloves, a hard hat and ear defenders.
• Do not start the tool when it is upside down or when it is
not in the operating position.
• Switch the motor off and disconnect from power when
the tool is not being used, left unattended, being
cleaned, being moved from one place to another or
when the extension cord is entangled or damaged.
• Do not operate the tool near people, especially children
or pets. Turn it off if they get too close. Maintain a safe
distance of at least 5 m from other people when using
the tool.
• Never direct the blower tube towards bystanders or
pets. Never blow debris in the direction of bystanders
or pets. The operator is responsible for accidents or
hazards occurring to other people or their property.
• Do not handle the plug or the tool with wet hands and
do not use the tool in the rain.
7