Descargar Imprimir esta página

Echo CS-2510TES Manual Del Operador página 31

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

If you have any questions or problems, please contact your ECHO dealer.
Air filter
1. Lifting hook
2. T-wrench
3. Cleaner cover latch
4. Air cleaner cover
5. Air filter
Check before every use.
Close choke.
Raise the lifting hook, and towards the lower end.
Release the cleaner cover latch with T-wrench, and remove the air cleaner cover and the
air filter.
Brush off dust lightly, or wash it in a non-inflammable solvent if necessary, or replace the
air filter.
Dry it completely before installation.
Reinstall the air filter and cover, engage latch and return the lifting hook.
Check fuel system
Check before every use.
After refuelling, make sure fuel does not leak or exude from around fuel pipe, fuel grommet
or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using he machine immediately and request your dealer to inspect or replace.
Fuel filter
Petrol and fuel are extremely flammable.
Extreme caution is required when handling petrol or fuel.
1. Fuel filter
2. Fuel tank cap
Check periodically.
- Do not allow dust to enter fuel tank.
- A clogged filter will cause difficulty in starting engine or abnormalities in engine
performance.
- Pick up the fuel filter through fuel inlet port with a piece of steel wire or the like.
- When the filter is dirty, replace it.
- When the inside of the fuel tank is dirty, it can be cleaned by rinsing the tank out with
petrol.
Oil filter
1. Oil filter
2. Oil tank cap
Check periodically.
- Do not allow dust to enter oil tank.
- A clogged oil filter will affect the normal lubricating system.
- Pick it up through oil filling hole with a piece of steel wire or the like.
- If the filter is dirty, wash it in petrol or replace it.
- When the inside of the oil tank gets dirty, it can be cleaned by rinsing the tank out with
petrol.
Spark plug
∗ Spark plug gap: 0.6 to 0.7 mm
Check periodically.
- The standard spark gap is 0.6 to 0.7 mm.
- Correct the spark gap if it is wider or narrower than the standard gap.
Fastening torque: 10 to 15 N•m (100 to 150 kgf•cm)
Service
DANGER
31

Publicidad

loading