Publicidad
Idiomas disponibles
Idiomas disponibles
GB
ROLLING-CODE SYSTEM
The FM400 and NOIRE series have rolling-code systems. This provides an
extremely high level of security, since there is no risk of cloning of the code
transmitted.
CAUTION! In the NOIRE series, the Rolling-Code function can be disabled
by removing the jumper JP1.
RECOMMENDATIONS
- Before doing any wiring or modifications to the connections, cut the power
supply.
- Non-observance of the above instructions could adversely affect the proper
operation of the device.
Cardin elettronica S.p.A disclaims all responsibility for any malfunctions
and/or damage caused by failure to observe the above instructions.
TRANSMITTER PROGRAMMING
The following description covers the procedures for memorizing transmitters
directly in the receiver; for programming with PRG, refer to the relative manuals.
OC2 receivers have two outputs and a number of options, with the following rules:
- the same code cannot be programmed on more than one channel of the same
receiver.
- only pulse operating mode is enabled in output (1).
- the code memorized activates one function of the circuit board connected. For
operation and options, refer to the control unit manual.
- during programming, keep the transmitter and receiver about 50 cm apart.
- all the codes programmed in a receiver are stored in the memory chip (M, fig. 1).
If the memory chip is moved to another receiver (of the same series), the entire
programming is retained.
Self-learning of codes for operation of output 1
This output is usually combined with the control unit's Step/Step control.
- Press button P1 (fig.1) quickly on the receiver.
- LED L1 blinks 5 times.
- During the blinks, press the key of the code to be memorized on the transmitter.
20
Publicidad
