Publicidad
Idiomas disponibles
Idiomas disponibles
GB
The LED on the receiver gives a longer blink to confirm that it has been
memorized correctly.
Repeat the self-learning operation for any other transmitters.
Self-learning of codes for operation of output 2
This output (second channel) may not be available in some control unit models.
There are three different learning procedures, each of which assigns a different
operating mode:
1) PULSE mode: the output is only active during radio transmission.
- Press button P2 (fig.1) quickly on the receiver.
- LED L2 blinks 5 times.
- During the blinks, press the key of the code to be memorized on the transmitter.
The LED on the receiver gives a longer blink to confirm that it has been
memorized correctly.
Repeat the self-learning operation for any other transmitters.
2) STEP/STEP mode; the first transmission activates the output (ON) and the next
one deactivates it (OFF).
- During programming, press key P2 (fig. 1) twice.
- LED L2 will blink twice, 5 times.
-During the blinks, press the key of the code to be memorized on the transmitter.
- The LED remains on steadily for a few moments to confirm that the learning
procedure has been successful.
If the power supply fails with the output activated, it is deactivated.
3) TIMER MODE: after release of the transmission button, the output remains on
for 30".
- During programming, press key P2 (fig. 1) three times.
- LED L2 will emit 5 sets of 3 blinks.
- LED L2 remains on steadily for a few moments to confirm that the learning
procedure has been successful. The output relating to key P2 is now operational
in timer mode.
With the NOIRE and FM400 software and the relative programmers, the timer
time setting can be programmed from 1 to 255 seconds.
21
Publicidad
