Accessmatic Falcon 350 Manual De Usuario página 45

AC24NE
(Figure 4)
Step 2: System Learning
Step1:
Press and Hold the Press SET button for 3s, When LED shows "LEA" then release SET, then the motor runs the
system learning procedure automatically, once learning completed shows "D-G" or "S-G"
(No remote required)
Note: Please check the parameter setting of "FI"(Dual/Single) before going into system learning.
Restore system default setting
Press and Hold the UP + SET + DOWN button for 5s and panel restores back to default setting
LED1
Note:
LED2
1) LED Shows "D-G" tells the system learning has be completed for Dual Gate installation
LED3
2) LED Shows "S-G" tells the system learning has be completed for Single Gate installation
UP
SET
1
A) Dual Gate:
(1) Slave Gate Close → (2) Master Gate Close → (3) Master Gate Open →
ON
(4) Slave Gate Open → (5) Slave Gate Close → (6) Master Gate Close
OFF
(RF-LEARN)
DKY
10 sec
Press
3 Sec
2
DAL
LEA
3
Opening your life
(RF-LEARN)
D-G/S-G
1 15