Stiga BT 540 Li 48 Manual De Instrucciones página 49

Output: 48V (Nominal)
• The equipment shall not be exposed to dripping
or splashing, and no liquid container, such as
pots, shall be placed above the equipment.
• The charger is designed for rechargeable
lithium-ion batteries. Some other types
of batteries may explode, resulting in
personal injury and property damage.
• Only charge rechargeable batteries.
• The LED lights a flashing green during charging
and a steady green when charging is complete.
• The transformer external flexible cable cannot
be replaced; if the cable is damaged, the
whole transformer must be disposed of.
• The line voltage can be disconnected
by pulling the mains socket.
• The socket must be positioned close to
the tool and must be easily accessible.
CHARGING PROCEDURE
NOTE Battery is shipped not fully charged. It
is recommended to charge it before use to ensure
that the maximum operating time is reached.
The lithium-ion battery does not have a charge
memory and can be recharged at any time.
1. Connect the charger to an AC outlet.
2. Put the battery pack (1) into the charger (2).
CG 500 Li 48
1
2
This is a diagnostic charger. The LED charger
lights (3) will light in a specific order to
communicate the current battery status.
CG 500 Li 48 - CGF 500 Li 48
DESCRIPTION
Battery charging
Fully charged
Overheated battery:
(remove for approx. 30 min.
to allow it to cool down)
3A
CGF 500 Li 48
1
2
3
LED STATUS
☼ Flashing green
● Green
● Red
No battery
Faulty battery
(remove and replace
with a new battery)
NOTE When the red indicator flashes,
remove the battery from the charger and re-
insert it within 2 hours. If the indicator shows
charging, the battery is in optimal condition.
After 2 hours, remove the battery and
disconnect the AC outlet from the charger
for 1 minute, then connect the AC outlet and
the battery again. If the indicator shows
charging, the battery is in optimal condition.
Otherwise, the battery must be replaced.
CHECKING THE CHARGER
If the battery pack does not charge properly:
• Check the output power with another tool.
Make sure that the outlet is not isolated.
• Check the charger contacts against short
circuit caused by debris or other materials.
If the battery is inserted into the charger
when it is hot or overheated, the LED LOAD
indicator light on the charger may light RED.
In this case, let the battery cool down out
of the charger for about 30 minutes.
NOTE If the battery and charger are not used
for a long period of time, remove the battery
from the charger and disconnect the AC outlet.
IMPORTANT SAFETY INSTRUCTIONS
• KEEP THESE INSTRUCTIONS DANGER: TO
REDUCE THE RISK OF FIRE OR ELECTRIC
3
SHOCK, IT IS IMPORTANT TO FOLLOW
THESE INSTRUCTIONS CAREFULLY.
• Before using the charger, check the
available voltage in each country.
6. CLEANING
To avoid the risk of fire
and electric shock:
• Do not use damp cloths or detergents
on the battery or the battery charger.
• Always remove the battery pack before
cleaning, inspecting or servicing the tool.
Clean the outside of the charger with a soft,
dry cloth. Do not rinse or clean with water.
EN - 4
○ Off
☼ Flashing red