Orbegozo CP 72120 Manual De Instrucciones página 13

CP 72120
INSTALLING THE REMOTE CONTROL RECEIVER.
Follow the diagram to install the remote receiver.
OPERATING YOUR FAN
- Select the fan speed by pressing the speed control button on the remote control transmitter :
HI: High Speed MED : Medium Speed LOW : Low Speed OFF : Off
- The switch on motor housing for controlling the fan blades rotating direction controls the
direction of air movement.
- Caution : Before using this rotating direction switch, turn OFF the fan and ensure the fan stops
rotating to prevent injury to yourself and damage to the moto.
- Cold weather: Push the switch 'UP' so that the blades will bring the warm air trapped near the
ceiling fan to move downwards throughout the room.
- Hot weather: Push switch 'DOWN' so that the blades will create a breeze and circulate the air
to the room.
- Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning on
or off of the light.
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch the light
and fan on or off.
- Replace the batteries by sliding the battery compartment cover on the remote control
transmitter in the direction of the arrow, fit 2 x 'AAA' batteries, and ensure the polarity of
the batteries match with the figures shown in the battery compartment. (Note : Batteries
NOT included).Re-assemble the battery compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
13