Pentair BLUEFURY Guia De Instalacion página 8

Step 3: Connecting Hose Sections
1. After the hose sections have been cut to size,
reconnect them by pushing the hose end over the
barb on the swivel.
Note: Be sure to push the hose all the way to the
bottom of the barb.
2. Move the mender nut toward the hose by turning
clockwise and rotating until tight on hose. Use
pliers if needed.
Note: Be sure the same number of floats are left
on hose sections 2 and 3, as described in Step 2.
3. To check that the hose is cut to the correct
length, reconnect the hose and wall fitting to the
wall adaptor. Take the opposite end of the hose
assembly and walk to the farthest point of the pool
from the wall adaptor. The hose should reach the
edge of the pool but should not extend more than
15cm (6 inches) beyond the pool edge.
4. You can now connect the cleaner to the hose.
First Swivel
Figure 13.
371674 (REV 02/2014)
Wall Fitting
Feed Hose
Second Swivel
Furthest Point of
Pool Perimeter
Measuring the Feed Hoses
Barb on
Feed
Swivel
Hose
Connecting the Hoses to Swivels
Figure 12.
(1)
Feed Hose
(2)
Lead
Hose
Mender Nut
WATER FLOW
DIRECTION
8