Publicidad
Idiomas disponibles
Idiomas disponibles
• Only operate the steamer on the floor clear of any
materials which may obstruct the base of the
steamer, ensure the floor is dry, flat, stable and
heat-resistant. Do not obstruct the openings on the
lower part of the appliance. This device should not
be used on very thick carpets or rugs.
• Expand the pole to the maximum height by
unlocking it, pulling it gently and locking it again -
fig.15
.
• Plug in the power cord and switch the power 'ON'
on the side of the appliance. The power light
indicator must illuminate.
• Select the proper steam flow level according to the
type of fabrics (3 different settings to perfecly
adapt the steam output to all fabric types, from
delicate to thick ones) -
• Press the button on the handle: 'steam on demand
system', the steamer is in a ready mode. Press the
button again, steam will start to come out -
• The steamer produces steam in 60 seconds.
• Put the garment directly on another hanger that
you can hang up on the hook. You can use the
removable clips to fix a pant or skirt from the top
or to stretch a garment from the bottom.
• Grasp the steam head with the steam vents
pointing away from you. Start steaming by
brushing material lightly with the grain of the fabric
in an up/down vertical motion. The fabric brush
opens the weave of the fabrics for better steam
penetration.
• Start at the top the garment and gradually move
downward. Always steam in a vertical position -
fig.18
.
• For more ease, we recommend to pull the garment
downward with your free hand while steaming. Be
careful not to touch the hot steam.
• During use, the hose may make a gurgling noise.
This is a normal occurrence due to condensation. If
you hear the gurgling noise, hold the hose up to
direct the condensation back into the appliance.
• Hang the steam head in an upright position on the
hook when not in use.
fig.16
.
fig.17
.
Warning: Do not allow
the steamer to run dry.
Warning: Do not bend
the steam hose during
use or storage.
EN
5
Publicidad
