Publicidad
Idiomas disponibles
Idiomas disponibles
Oszillosäge TITANIUM II Accu
4 Mounting / exchanging the saw blade
!
4.1 Releasing the retaining screw / removing the old saw blade
1.
Place the cast cutting saw on a stable underlay (table).
2.
Apply one fork wrench at the drive shaft behind the saw blade, and the other one at the front at the
retaining screw (see
3.
Hold the rear wrench firmly and use it to fix the cast cutting saw.
4.
Release the retaining screw using the front wrench.
5.
Remove the retaining screw and the fixing ring. Ensure that you do not lose any components.
6.
If applicable, remove the old saw blade.
4.2 Inserting the new saw blade
1.
Check that the female thread and saw blade support of the drive shaft are clean.
2.
Position the new saw blade. It makes no difference which side of the saw blade is
facing inwards or outwards.
Important! The notches in the saw blade must be positioned precisely flush on the
spigots of the drive shaft.
3.
Position the fixing ring. The notches in the fixing ring must always be pointing towards
the saw (see
fig. 4
Danger of injury when unintentionally turned on. Remove
accumulator before changing. Should it be necessary, use stable
gloves so that you Can not be injured by the saw blades. Only
connect the accumulator when the saw is switched off.
).
fig. 3
fig. 3 Releasing the retaining screw
). These must also be positioned precisely on the spigots.
EN
19
Publicidad
