HIKOKI C 1807DA Instrucciones De Manejo página 14

English
○ When the pilot lamp fl ickers in red (at 0.2-seconds
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery or charger is
malfunctioning. Take it to your authorized Service
Center.
○ Since the built-in micro computer takes about 3 seconds
to confi rm that the battery being charged with chargers
are taken out, wait for a minimum of 3 seconds before
reinserting it to continue charging. If the battery is
reinserted within 3 seconds, the battery may not be
properly charged.
MOUNTING AND OPERATION
Action
Inclined cutting using the guide
(+45° direction)
Adjusting the base and saw blade to
maintain perpendicularity
Adjusting the cutting depth
Adjusting the angle of inclination
(0°–45°)
Adjusting the angle of inclination
(45°–55°)
Regulating the guide
Cutting line
Switch operation
About the mode select function (*1)
Remaining battery indicator
Using the LED light
Mounting the dust collector set
Removing and inserting the battery
Charging
Cutting (Do not use the tool with only
the blower function.)
Dismounting the saw blade
Mounting the Saw Blade
Selecting accessories
Safeguard Function
Overburden Protection
Temperature Protection
Figure Page
9 3
10 3
11 3
12-a 3
12-b 3
13 3
14 3
15 4
16 4
17 4
18 4
19 4
20 4
21 5
22 5
23 5
24 6
― 243
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
(*1) About the mode select function
Each time the mode selector switch is pushed, the
operation mode changes.
When Silent mode is selected, the Silent mode indicator
lamp lights up.
Silent mode reduces maximum motor RPM enabling
effi cient work with less noise.
If the load increases while the motor is operating in
Silent mode, it automatically changes to Power mode.
Additionally, if the load decreases again, it automatically
returns to Silent mode.
In Power mode, no change is made to Silent mode even
when the load decreases.
Mode
Power
Silent
NOTE
○ The mode will only change after a battery is installed and
the switch is pulled once.
○ The current mode will be maintained even if the switch is
on/off , or the battery is removed/reinserted.
LED LIGHT WARNING SIGNALS
(Fig. 25)
This product features functions that are designed to protect
the tool itself as well as the battery. While the switch is
pulled, if any of the safeguard functions are triggered
during operation, the LED light will blink as described in
Table 3. When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and follow
the instructions described under corrective action.
Table 3
Remove the cause of the overburdening.
Allow the tool and battery to thoroughly cool.
14
No-load speed
3800 min
-1
2000 min
-1
Fig. 25
Corrective Action