Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust High/Low Flame Setting Screw
When converting from LP to Natural gas, you will need
to adjust the high flame setting screw for ideal burner
flame height.
1. Remove each control knob for the main burners
and side burner
2. Use a flat-blade screwdriver to turn the high flame
setscrew counterclockwise approximate 90º.
3. Check that burner operates at the new high flame
setting. It may be necessary to adjust the screw
setting slightly more to get the ideal burner flame
height.
If flame goes out on the "LOW" setting, the low flame
setting must be adjusted.
1. Turn off the valve and wait until grill and burners are cool.
2. Remove grill grates and flame tamers.
3. Light grill using information in the "Outdoor Grill Use"
section.
4. Turn burner to its lowest setting.
5. Remove each control knob for the main burners and
side burner by loosening the setscrew with the hex key.
6. Hold valve stem with pliers and insert a small flat-blade
screwdriver into the shaft.
7. Watch the flame and slowly turn the screwdriver
counterclockwise.
8. Adjust flame to minimum stable flame.
9. Replace the control knob and turn off the burner.
10. Repeat steps 3 through 9 for each burner if needed.
11. Replace the flame tamers and grates after the burners
have been cooled.
Publicidad
