BHG 720-0783W Manual página 7

WARNING
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and body a
safe distance (at least 18 inches) from the
cooking grid surface when lighting your grill by
match.
Manually Lighting Your Grill by Match
1. Insert a match into the manual lighting stick.
2. Follow steps 1 through 8 of the Lighting
instructions on page 6.
3. Light the match and extend the lighting stick to
cooking grid surface.
4. Turn the desired control knob to the HIGH
position setting to release gas. The burner
should light immediately.
WARNING
Should a "FLASH-BACK" fire occur in/or
around the burner tubes, follow the
instructions below. Failure to comply with
these instructions could result in a fire or
explosion that could cause serious bodily
injury, death, or property damage.
 Shut off gas supply to the gas grill.
 Turn the control knobs to OFF position.
 Put out any flame with a proper fire extinguisher.
 Open grill lid.
 Once the grill has cooled down, clean the burner
tubes and burners according to the cleaning
instructions found on page 8.
If Grill Still Fails To Light
1. Check gas supply and connections for leaks.
Check that all wire connections are secure.
2. Repeat basic lighting procedure. If your grill still
fails to operate, turn the gas off at source, turn the
control knobs to OFF, then check the following:
Misalignment of burner tubes over orifices
Correction: Reposition burner tubes over orifices.
Plugged orifice
Correction: Remove burners from grill, carefully
lift each burner up and away from gas valve orifice.
Remove the orifice from gas valve and gently clear
any obstruction with a fine wire. Then reinstall all
orifices, burners, and cooking components.
3.If an obstruction is suspected in grill burner valves,
please call for repair service at 1-800-913-8999.
4.If the grill still does not light you may need to
purge air from the gas line or reset the pressure
regulator.
Note: This procedure should be done every time a
new LP gas tank is connected to your grill.
To purge air from your gas line and/or reset the
pressure regulator:
Turn all control knobs to the OFF position.
Turn off the gas at the tank valve.
Disconnect pressure regulator from LP gas tank.
Let unit stand for 5 minutes.
Reconnect pressure regulator to the LP gas tank.
Turn the tank valve on slowly until ¼ to ½ open.
Open the grill lid.
Push and turn any control knob to HIGH.
Turn control knobs to HIGH until all the burners
are lit.
You may start to use the grill.
5.If all checks or corrections have been made and
you still have questions about operating your gas
grill, call the Grill Information Center at
1-800-913-8999