Publicidad
Idiomas disponibles
Idiomas disponibles
English
connection mode.
•
Please ensure your device is in the correct WiFi connection mode for the
connection type you are attempting, the flashing WiFi indicator
your heater will indicate this.
Connection Type
Quick Connection
AP (Access Point)
•
To change the unit into AP mode, with the appliance in Quick Connection
mode, press and hold the DOWN
Changing between connection types:
•
connection mode, press and hold the UP
Turning the WiFi OFF:
•
off using the switch on the rear. When the unit is turned back on, it will start
with the WiFi turned off, until reactivated following the steps above.
10.
Once the
the add device button at the bottom.
11.
Select the type of device as "Heater" within the Home Appliance tab.
12.
Ensure the WiFi indicator
bottom of the screen. You will then be prompted to enter WiFi password. This
allows the app to find your heater using your WiFi and then displays its con-
nection screen.
13.
Wait for this to complete. A solid icon
is successfully connected. If this fails retry.
14.
After the device is connected successfully, the device name shows in the list.
Tap it to enter the control panel of the heater.
15.
Now you can operate the appliance using the app.
NOTE: The appliance can only be operated with 2.4 GHz routers. 5 GHz routers
are not supported. The appliance is equipped with only one network connection.
12
to turn the WiFi off, the appliance must be turned
icon is flashing, go to app and press "+" to add device, or use
is flashing then press on the orange button at the
Frequency of Flashes
Flashes twice per second
Flashes once per second
button for 3 seconds.
to change back to Quick
button for 3 seconds.
will be displayed when the device
Instructions for use
on
Publicidad
