Vonyx VX2USB MK2 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
OVERVIEW
1. POWER ON/OFF SWITCH
Push this button to turn power ON and OFF, the button lights red when the power is on.
2. DISPLAY
Display indicates the most important settings and data such as track number, track title and folder name, playing time and other
information.
3. SD CARD FLASH DRIVE
The connector to insert the SD CARD.
4. USB FLASH DRIVE
The connector to insert the USB flash drive.
5. TRACK/FOLDER KNOB
Turn the knob clockwise to search the tracks. Press this button, display shows "FOLDER", then the function of the knob is
"FOLDER SEARCHING".
Press this button again to exit "FOLDER SEARCHING" function.
6. MODE FUNCTION
Press this button to switch between BT, SD and USB.
7. PLAY / PAUSE
Press this button to play or pause the music.
8. STOP
Press this button to stop the music.
3