Eden ED-7016 Manual De Usuario página 12

Instruction manual
TROUBLESHOOTING
Troubles Possible Causes
The unit • Water full indicator
does not lamp blinks and water
start tank is full.
when • Room temperature is
pressing higher than the setting
power temperature.(Electric
button. heating mode)
• Room temperature is
lower that the setting
temperature.(Cooling
mode)
The unit • The doors or windows
doesn't are not closed.
cool • There are heat
enough. sources inside the
room.
• Hot air exhaust hose
is not connected or
blocked.
• Temperature setting is
too high.
• Air inlet in blocked.
12
Suggested Remedies
• Drain the water out of the
water tank.
• Adjust the temperature.
• Make sure all the
windows and doors are
closed.
• Remove the heat sources
if possible.
• Connect or clean the hot
air exhaust hose.
• Reset the temperature.
• Clean the air inlet.
Auto • Heating protection,
Power-Off when the temperature
in heating at the air outlet
mode. exceeds 70 degrees,
the unit will power off
automatically.
Noisy. • The ground is not
level or not flat
enough.
• The sound comes
from the flowing of the
refrigerant inside the
air conditioner.
E0 Code. • Room temperature
sensor failed.
E2 Code. • Water tank full
TABLE ERP ED-7016
Information requirements for single
and double duct air conditioners
Information to identify the model(s) to
which the information relates to:
Description
Rated capacity for cooling
Rated capacity for heating
• Allow room temperature
to cool before re-starting
the unit.
• Place unit on a flat, level
ground if possible.
• Replace room
temperature sensor.
• Please empty the water
tank.
P
Symbol Value Unit
Prated 2,05 kW
Prated N/A kW