fadini HINDI 880 - evo Manual De Instrucciones página 21

HINDI 880 - evo
ADJUSTING THE THRUST POWER
In order to adjust the thrust power in opening and closing loosen or tighten the screws located inside the valve block cover, to be
accessed by the dedicated coded key (Pic. 19).
Red screw = it adjusts the thrust power in the closing cycle of the gate/s.
Green screw = it adjusts the thrust power in the opening cycle of the gate/s.
INSTALLING THE ELECTRIC LOCK
An electric lock is always required to be fitted to the gate/s whenever Hindi 880-evo corresponds to the reversible version (non
locking action by the hydraulic circuit) and the gate leaf is wide up to or wider than 2,0 meters (Pic. 20 and Pic. 21).
Horizontal electric lock
Horizontal electric lock
on the gate leaf closing
second.
This solution is recommended
for single gate installations.
universal oil-hydraulic operator for swing gates
Screwdriver
to adjust power
Gate latch in closed
position welded to the
gate leaf closing first.
Gate stop plate
in closed position
to be fixed
to the ground.
Thrust power in closing (red):
Clockwise = + power
Anti-clockwise = - power
Thrust power in opening (green):
Clockwise = + power
Anti-clockwise = - power
Electric lock catching
plate to be fitted to
the gate leaf closing
first.
Pic. 20
21
Vertical electric lock
Gate stop plate
in closed position
Electric lock
Electric lock
in vertical
catching plate
position
to be fixed to
the ground
Pic. 19
Pic. 21