Publicidad
Idiomas disponibles
Idiomas disponibles
•
Fill engine crankcase with oil. A 20oz. bottle has been provided with this unit. A new unit
requires 18-20oz. DO NOT OVERFILL.
•
Fill the engine fuel tank with gasoline. GASOLINE SHOULD BE ADDED OUTSIDE IN A
WELL-VENTILATED AREA.
•
Check to ensure string has been installed properly. A diagram is provided just above the
trimmer head for proper installation.
•
Refer to engine manufacture's manual for oil and fuel specifications.
Important! To ensure proper operation, clean the engine and trimmer
regularly. Remove any build up of chaff from the top of the engine.
To stop the trimmer:
•
Release the control bail. Engine will stop immediately.
To start the trimmer:
•
Remove any built up debris from engine.
•
Pull control bail against the handle and hold.
•
Push primer button on engine as directed.
•
Pull back sharply on recoil starter handle.
•
Begin trimming.
Important! For safest operation, make sure debris is directed away from you and others.
•
Do not lift the trimmer head when trimming. Let the head rest lightly touching the ground.
•
Keep an eye on the length of the trimmer line. As the line gets shorter they become less
effective at cutting and will take longer to trim properly. Replace the line as necessary (see
Installing Trimmer Line).
•
Do not trim wet grass.
•
Use caution when trimming slopes.
•
Use the proper length of line. Using a line too long for the unit will cause stalling and
unacceptable operation.
If engine will not start, remove and check air filter to make sure filter and
•
carburetor are clean.
Preparing Unit For First Use
Operation
Trimming Tips
Troubleshooting
7
Publicidad
