Beper BT.607 Manual De Instrucciones página 9

EN
3in1 Snack Maker Use instructions
FIRST USE
The product is equipped with 3 different types of plates depending on the use you will prefer:
- For biscuits
- For waffle
- For sandwich
Before starting to use the product, mount the desired plate, place it on the lower surface, taking care to insert
the two wider hooks on the upper part of the plate into the two holes on the body of the product, at this point
press slightly until you will hear a slight "click" that indicate that the plate is correctly hooked. Repeat the same
operation for the top plate.
To remove the plates, move the appropriate button slightly in the direction of the arrow.
Remove and change the plates only when they have cooled down.
Before the first use, we advise you to clean the baking plates (6-7) with a soft damp cloth. Put some butter or
olive oil on the surfaces of the baking plates.
During the first use, the non-stick coated baking plates could produce some smoke; this is NOT harmful, it is
normal and will disappear after a short time. and to operate the appliance for 5 minutes without food. We suggest
to open the window to let the smoke and smell go outside.
Place the appliance on a stable and hot resistant surface.
Pay attention that the power cable will not touch hot surfaces.
USE
Insert the plug in the power socket, the pilot light will switch on (green light -1)
The appliance starts to preheat; when the cooking temperature is reached, then the ready light (red light -2) will
come on and the appliance is ready for use.
Fully open the appliance. Place the bread on the baking plate.
Close the appliance and check the food during the cooking process.
Your waffle will be ready in 2 to 3 min or longer to suit your taste. Open the appliance and remove the toast using
a plastic or wooden spatula. Never use a metal knife as this may damage the non-stick coating.
When the cooking is finished unplug the appliance from the socket.
If necessary move the appliance while in use, use the handle, the parts of the appliance will be hot and can burn.
NEVER TOUCH THE SURFACE OF THE APPLIANCE WHILE IN USE, IT IS HOT.
ATTENTION: The temperature of the outer surface may be high when the appliance is operating.
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, switch it off, remove the plug from the outlet and wait for it to cool.
Use a soft, slightly damp cloth to clean the body; do not use metal scouring pads or abrasive pro ducts.
Don't immerse the product in the water
Replace the appliance only when completely dry and cool.
TECHNICAL DATA
Power: 780W
Power supply: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9