EINHELL 34.140.28 Manual De Instrucciones Original página 6

1. Scope of delivery
1. Fastening peg
2. Magnetic tape
2. Magnetic tape (Fig. 2 - 6)
Obstacles such as fences and hedges which
poorly refl ect the distance signal transmitted by
the robot lawn mower are not detected in part
or only very late. Obstacles with a weak optical
contrast relative to the mowing areas can also be
diffi cult to recognize. Such areas can be protec-
ted by magnetic tape as a safe and contact-free
means of getting the robot lawn mower to change
its direction.
The magnetic tape serves as a mobile and tem-
porary boundary in the mowing area. The magnet
sensors installed in the robot lawn mower detect
the magnetic tape and turn away at its limits. In
this way you can separate off parts of the garden
which are off limits, for example:
•
Short-term separation of a part of the garden
for a garden party where the robot lawn mo-
wer is not allowed to enter.
•
Placement of a trampoline or swimming-pool
in the mowing area over the summer months.
•
A recently planted tree is still very sensitive
and is best protected at an early stage from
collisions with the robot lawn mower.
•
A seasonal flower meadow is planned to
attract insects. This area is off-limits for the
robot lawn mower and needs to be protected
from the outset.
•
A new lawn has been sown in one area and
you want to protect this area initially. The
subsoil is still not firm and you want to wait for
strong turf to form.
Anl_Magnetband_SPK13.indb 6 Anl_Magnetband_SPK13.indb 6
GB
Lay the magnetic tape a few centimeters away
from the area or object in question. Shorten the
magnetic tape to suit your requirements (50 cm
minimum length). To enable a boundary made up
of several magnetic tape elements to be recog-
nized reliably, the maximum distance between the
respective ends should not exceed 8 cm (Fig. 5).
Make sure that the outer boundary of the mowing
area is defi ned by an optical or physical separa-
tion. Fasten the magnetic tape to the ground by
means of pegs spaced a maximum of 1 m apart.
Keep a distance of at least 80 cm away from
the guide cable and between two independent
boundary areas so that the robot lawn mower can
travel through without diffi culty. (Fig. 6).
Avoid laying the magnetic tape on gradients be-
cause in such cases there is a risk of the robot
lawn mower slipping out over the boundary area
and the boundary not being recognized.
Like the guide cable, the magnetic tape can be
installed both on the ground and at a depth of ap-
prox. 5 cm in the ground. Take care not to lay the
magnetic tape too deep in the ground because
then there is no longer any guarantee that it will
be recognized by the robot lawn mower.
- 6 -
24.11.2022 13:02:48 24.11.2022 13:02:48