EINHELL 34.140.28 Manual De Instrucciones Original página 7

3. Troubleshooting
Fault
The robot lawn
mower fails to reco-
gnize the magnetic
tape and travels
over it and past it.
The robot lawn mo-
wer stops or travels
out of control when
it is near the bound-
ary area.
The robot lawn mo-
wer intrudes in the
boundary area.
Anl_Magnetband_SPK13.indb 7 Anl_Magnetband_SPK13.indb 7
GB
Possible cause
- The magnetic tape is laid too
deep in the ground.
- The magnetic tape does not
work properly because the
outside temperature is too
high.
- The magnetic tape is laid too
close to the guide cable. The
distance between two inde-
pendent boundary areas with
magnetic tape is too small.
- Interference arises in the
mowing area due to electric
cables.
- The robot lawn mower slips
over the magnetic tape.
- 7 -
Remedy
- Lay the magnetic tape on the ground or at
a depth of approx. 5 cm in the ground.
- Wait for the temperature to cool. Avoid
operating the robot lawn mower during the
hot hours of the day.
- Keep a distance of at least 80 cm bet-
ween the guide cable and the magnetic
tape or between two boundary areas.
- Avoid electric cables which run through
the mowing area. Position the charging
station at the edge of the mowing area.
Keep away from mowed areas which do
not belong to you but to your neighbors,
for example, and which are operated with
a perimeter wire.
- Avoid laying the magnetic tape on gradi-
ents.
- Take account of the specifi ed conditions
of installation.
24.11.2022 13:02:48 24.11.2022 13:02:48