Hilti Nuron DSH 700-22 Manual De Instrucciones Original página 27

1.3.2 Hazard warning symbols
The following symbols are used on the product:
General hazard
Hazard due to flying sparks
Hazard due to kickback
Warning: Do not inhale toxic vapors or exhaust fumes
Maximum spindle speed
1.3.3 Obligation symbols
The following obligation symbols are used on the product:
Wear ear protection, eye protection, respiratory protection and a hard hat
Wear protective gloves
Wear safety shoes
1.3.4 Prohibition symbols
The following prohibition symbols are used on the product:
Do not use toothed cut-off wheels
Do not use damaged cut-off wheels
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
DSH 600-22
Diamond cut-off saw
Generation
Serial no.
Product information
DSH 700-22
Diamond cut-off saw
Generation
Serial no.
1.5 Declaration of conformity
The manufacturer declares, on his sole responsibility, that the product described here complies with the
applicable legislation and standards. A copy of the declaration of conformity can be found at the end of this
documentation.
The technical documentation is filed here:
*2284136*
DSH 600-22
01
DSH 700-22
01
2284136 English 21