Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
• Equipment in conformity with Moroccan standards.
• The declaration C( مCMIM) of conformity is available on our
website (see cover page).
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
• The battery fitted in this device is recyclable. Please proceed
according to the applicable recycling regulations.
• The battery must be removed from the device before the latter is
discarded.
• The device must absolutely be disconnected from the power sup-
ply network before removing the battery.
GENERAL DESCRIPTION
This autonomous starter is intended for the starting of the vehicles equipped with a 12 V battery. GYSPACK functions
thanks to a battery high performance. For an appropriate use of the machine and a longer life cycle of its internal
battery, it is essential to connect the GYSPACK to the sector and to position the battery on OFF after each use. It is
recommended to leave it connected to the mains until further use.
USE IN A STARTER MODE
1- Test the battery
HIGH TECHNOLOGY
Pb
Test the battery before each use: press on the button test
INTERNAL BATTERY
HIGH TECHNOLOGY
Pb
INTERNAL BATTERY
12 V
Red indicator: obligation to reload. Warning: never use themachine when the red indicator lights on.
HIGH TECHNOLOGY
Pb
INTERNAL BATTERY
Orange indicator: It is strongly advised to reload before use.
TEST
Green indicator: The battery is charged. Possible starting.
TEST
2- Starting of a vehicle
1 - Leave the battery switch on OFF.
2 - Put the red grip at +, and the black grip at -.
When you hear a signal sound, you made an inversion of polarity.
In this case, disconnect and connect again the grips by respecting the polarity
3 - Put the battery switch in ON position.
4 - Turn your vehicle key (6 seconds maximum) to activate the starter function.
5 - Put the battery switch on OFF, then disconnect the GYSPACK.
6 - Charge the charger.
In general, a starting requires 400 to 500 A.
In case of several attempts, wait for a while before starting again (3 min).
A vehicle which does not start, can have a problem other than a battery discharge: alternator, plug
preheating,...
10
GYSPACK PRO 700 / 900
12 V
12 V
TEST
the result is posted:
TEST
EN
Publicidad
