Dell P126G Guia De Inicio Rapido página 15

FCC Radio Frequency (RF) Exposure Information
This device has been evaluated to, and shown to be compliant with, the FCC Radio Frequency
(RF) exposure limits.
Devices such as Desktop computers and Access Points (AP) that contain wireless functions (such
as 802.11, Bluetooth, 3G or 4G) must be installed to provide a separation distance of at least
20cm from people to ensure compliance with the RF exposure requirements.
Certain laptop/notebook computers, with antennas located toward the top of the screen, may
require a separation distance of at least 20cm between the antennas and persons when they are
operating to ensure compliance with the RF exposure requirements. These laptop/notebook
computers are designed such that, during normal use with the screen open, the antenna-to-user
distance is greater than 20cm.
Some devices may have additional requirements for operating conditions to ensure compliance
with RF exposure requirements. Specific instructions, where required, will be contained in the
manual for that device. Please read your operating manual carefully.
Interference Statement
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the manufacturer's instruction manual, may cause interference with
radio and television reception. This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
Notice: The FCC regulations provide that changes or modifications not expressly approved by
Dell Inc. could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference with radio or television
reception, which can be determined by turning the equipment off and on, you are encouraged to
try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the system with respect to the receiver.