Publicidad
Idiomas disponibles
Idiomas disponibles
Never lock the blade guard in its open
position except when changing blades as
described below.
Check that the blade guard can be moved
freely and that the closure mechanism works
correctly before use. Do not use the saw if
this is not the case.
Never use the guards to carry or lift the saw.
Never allow the blade to be in contact with
the item to be cut – or other objects – when
starting up the saw.
Check that there are no nails, screws or other
objects that could damage the blade in the
item to be cut, and that there are no similar
obstructions in the surface beneath the item.
Secure round objects to be sawn using
clamps or similar, as the rotation of the blade
may cause them to spin.
Do not use for routing or milling unless the
appropriate guards are � tted above the
bench, and never use for notching.
Replace the bench inlay once it is worn.
Illustrations
Please refer to the illustrations at the back of
these user instructions.
Main components
1.
Saw bench
2.
Bench inlay
3.
Saw blade
4.
Blade guard
5.
Dust extractor hose
6.
Cleaver blade
7.
Mitre guide
8.
Bench extension
9.
Push stick
10.
Frame
11.
On/off button
11a. Overload protection
12.
Hand wheel
13.
Lock knob
14.
Front rail
15.
Parallel guide
15a. Plastic guide
16.
Leg
16a. Rubber foot
16b. Anti-tip mechanism
17.
Long cross-brace
18.
Short cross-brace
19.
Bolt
20.
Nut
21a. Long support bracket for bench
extension
21b. Short support bracket for bench
extension
21c. Cross-brace
22a. Ring spanner 10/21 mm
22b. Ring spanner 10/13 mm
GB
33
Publicidad
