MEI AC 2980 H Manual De Instrucoes página 30

Cooling mode
Press the key "COOL" to start the cooling system. The water pump starts working and the water starts to
contribute for the air cooling. To cancel this function, press again this key.
IMPORTANT: Please be sure there is enough water in the water tank before press this key.
 Inserting water on the water tank
To insert water on the deposit proceed as following:
ON
Using the thermal accumulator with ice

Add some water to the thermal accumulator, without filling completely. Put in the freezer until it
freezes totally.

Place the thermal accumulator in the water tank.

There are two thermal accumulators that can be used each one on a time. Do not use both at the
same time to avoid the pump to block.
NOTE: The ice crystal has the particular feature of keeping cool, it can absorb heat from water and
maintain the water temperature in the water tank below room temperature, so the air will be much cooler.
The ice and the thermal accumulator are complements, they are not indispensable for the operation of the
appliance.
Heating
This key is not available for cooling function.
Pull the water tank 1/3 out, then, pour fresh water.
Pay attention to the water level on the deposit when you are
adding water.
The water level on the deposit should not be above the MAX
mark or below the MIN mark.
You can add some ice on the thermal accumulator on the
water tank, if you want to improve the cooling efficiency.
Place the water pump submerse on the water tank into the
position ON.
NOTE: The water pump should be on the OFF position in
order to remover de tank.
OFF
30