–
Plug in connector for the left supplementary headlight to the
wiring harness
–
Thread the connector for the right supplementary headlight
through to the left side and plug it into the wiring harness
–
Route the cables without tension and secure with a cable tie,
if necessary.
501720-01
–
Position the voltage regulator.
–
Mount and tighten screws
Guideline
Screw, voltage regu-
lator
501721-01
–
Remove left cover
501722-01
–
Drill a mounting hole with a diameter of 25 mm using an
appropriate drill (pre-drill to 17-22 mm).
Info
The position is marked on the cover.
501724-01
2
.
br
.
M6x30
10 Nm (7.4 lbf ft)
bs
.
ASSEMBLY 5
2
.
11