Perel Tools GZB2 Manual Del Usuario página 4

6. Breaking down
Refer to the illustrations on page 2 of this manual.
•
Remove any guy-ropes and stakes that were used to hold the gazebo in place.
5. Hold two adjacent legs of the gazebo. Simultaneously press on the spring-loaded buttons and
slide the inner legs into the outer legs. Repeat this step for the other two legs.
6. Release the sliding yoke at each corner. Push the sliding yoke slightly upwards and press on the
spring-loaded button. Slide the yoke down past the spring-loaded button. Do this for all 4
corners.
7. Hold the gazebo at opposite legs, lift and slowly step forwards until nearly closed. Shake the
canopy gently to facilitate folding. The yoke slides down over the leg; be careful not to get hands
or fingers injured by this yoke or any other hinging joints.
8. Close the gazebo completely by lifting and pulling the adjacent legs together.
•
Make sure the gazebo is completely dry before placing it inside the storage bag!
7. Technical specifications
aluminium legs
aluminium roof frame
peak height
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Components nv.
All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic
medium or otherwise without the prior written consent of the copyright holder.
00 (11/12/2008)
GZB2/GZB2PRO & GZB3/GZB3PRO
GZB2/GZB3
25 x 25/20 x 20mm
thickness 0.7mm
10 x 18mm
thickness 0.9mm
2.50m
water-resistant polyester
cover
(160gr/m²)
4
GZB2PRO/GZB3PRO
32 x 32/28 x 28mm
thickness 1mm
23 x 14mm
thickness 0.9mm
3.50m
waterproof nylon
© Velleman Components nv
®