Publicidad
Idiomas disponibles
Idiomas disponibles
ACTIVATE SLEEP FUNCTION
You can set a time of between 90 and 10 minutes, after which the device switches itself off.
• To activate a Switch-off time of 90 minutes, press the SLEEP button
• To set a shorter Switch-off time, keep the SLEEP button
• To switch off the Sleep function, press the SLEEP button
RADIO
ATTACHING AERIAL
If you use the wire aerial for FM reception:
• The wire must be fully wound out
• Determine the best position by trial and error
• Attach the wire aerial to the wall if necessary using a strip of adhesive tape.
For MW reception, place the device in the best position for the in-built aerial, again by trial and error.
OPERATING THE RADIO/ SELECT BAND (FM/MW)
01) Select
TUNER (=Radio) using the device selector button.
*
02) Select between FM (VHF) and AM (medium wave) using the BAND SELECTOR button
AUTOMATIC STATION SEARCH / MANUAL SEARCH
In an automatic search the frequency is increased or deceased until a station of adequate reception strength is found.
01) Hold down the
Forward button
02) To start the search again, hold down the
You can use the manual station search for fine adjustment or when the frequency of the station is known.
01) Press the
Forward button
02) Keep the
Forward button
STORE STATION
[ » MEMORY « ]
The Designer Audio Unit KH 2300 can store up to 40 stations (20 FM / 20 AM).
01) You set up the desired station by following the instructions relating to "Automatic station search/manual station search"
described above.
02) Press the MEMORY/CLK-ADJ button
You must carry out the next step within those 5 seconds, otherwise the device switches itself into normal display. If this happens,
press the MEMORY/CLK-ADJ button
03) Press the M-UP/REPEAT button
Repeat this procedure for all the other stations you require have been stored.
SELECT STORED STATION
Press the M-UP/REPEAT button
CD PLAYER
DANGER! The CD player uses a weak but sharply focussed laser beam to scan the surface of the CD. If the device is used improperly
then this light can be dangerous to the eyes - never open the case.
INSERTING A CD
01) To open the CD compartment
02) Insert the CD with the playing side facing towards the device. If you have done this correctly, you should be looking at the
printed side. The CD must be placed securely on the central pin.
03) Close CD compartment
.
!
04) Select the CD player with the device selector button
NOTE: When you insert a CD, if the display does not show the number of tracks and the total playing time then the CD is possibly
the wrong way round or dirty. Clean the CD with a CD cleaning cloth or insert the CD correctly and check the display again.
All manuals and user guides at all-guides.com
[ » SLEEP « ]
pressed until the desired time is displayed.
-
or
Reverse button
)
8
Forward button
)
or
Reverse button
briefly to increase or decrease the frequency in small steps.
)
8
or
Reverse button
pressed until you are close to the frequency you require.
)
8
once. Next the station number shows for 5 seconds on the left side of the display
\
again.
\
repeatedly until the required station number (1 to 20) is displayed.
=
repeatedly until the required station number (1 to 20) for the stored station is displayed
=
pull the top edge towards the front.
!
CD. The display
*
once briefly.
-
repeatedly until the display
-
@
.
_
for about 1 second – the search starts and stops automatically.
or
Reverse button
again for about 1 second.
8
shows the total playing time and the number of tracks.
@
13
no longer shows SLEEP.
.
@
.
@
Publicidad
