Adler europe CR 7732 Manual De Uso página 6

convector in the event of excessive temperature convector (due to clogged vents, fan
malfunction ) . In this case, disconnect the unit from the power supply , waiting a few
minutes and remove the cause of overheating,
21. Do not touch the hot parts of the convector . Do not touch the appliance with wet hands.
22. In the case of wet convector or falling of any object through the ventilation grille of the
convector , turn it off immediately and disconnect from the network. Before re- use
with convector call for service .
23. Do not place the convector directly below the electrical outlet.
24. Always turn off the convector button before disconnecting it from the mains.
25. Do not use this heater in the immediate vicinity of a bathtub, shower or swimming pool
26. Do not use this heater if it has been dropped
27. Do not use if there are visible signs of damage to the heater
28. Use the heater on a level and stable surface or attach it to the wall, if provided for by the
manufacturer
WARNING: Do not use this heater in small rooms where there are people who are unable
to leave them by themselves, unless constant supervision is ensured.
WARNING: To reduce the risk of fire, keep textiles, curtains or other flammable materials at
least 1 m away from the heater air outlet.
"Caution Hot Surface" - The temperature of accessible surfaces may be higher when the equipment is in operation, which
means that the housing elements become hot during operation during operation, BE CAREFUL !!!
WARNING: In order to avoid overheating - do not cover the heater. The device is not to be covered with clothing, blankets
and other textile products which could cause ignition.
DEVICE DESCRPTION (Fig. 1)
1. Indication lamps
3. Handle
5. Decorative ring
7. Power switch
Control Panel (Fig. 2)
9. Standby button
10. Temperature regulation button
11. Heating power regulation button
11B. High heating power 1500W indicator
12. Timer button
USAGE
1.Plug in the device to a 220-240V~50Hz socket.
2.To start the device, press the power switch (7) located at the back of device.
3.The standby indicator (9A.) on the control panel lights up.
4.Press the standby button (9) to activate the device.
5. The device will blow cold air from fan, the fan function indicator (9B.) will be lighted up.
6.Press the heating power regulation button (11) to choose suitable power level:
- to get low heating power 1000W press once, at the same time the indicator (11A) will light up,
- to get high heating power 1500W press twice, so both indicators (11A + 11B) will be lighted up.
7.Press the timer button (12) to set the countdown time to turn off your heater automatically when the heater is on. You can set up the
heating time by repeated pressing the timer button (12), the desired heating period will be shown by indicators (12A). To switch off the
timer function press button (12) again. The maximum heating time is 7 hours.
8. The device is equipped in digital thermostat control. During operation, press the temperature regulation button (10) to set the desired
temperature (15°C / 20°C / 25°C / 30°C / 35°C) /15°C when the room temperature rises to the set temperature, the heater will stop
heating until the moment the temperature drops a few degrees. After choosing the desired temperature level one of indicators (10A) will
be lighted up.
Note: The temperature set using the temperature regulation button (10) button will not be reached if it is less than the current room
temperature.
2. Control panel
4. Air outlet grid
6. Feet
8. Air inlet grid
9A. Standby indicator
10A. Desire temperature level indicators
11A. Low heating power 1000W indicator
12A. Desired heating period indicators
6
9B. Fan function (cold air) indicator