Descargar Imprimir esta página

Xtech Floyd XTS-610 Guia De Inicio Rapido página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Built-in microphone: Use it for hands-free calling and conferencing.
2. Status LED:
• In Bluetooth
mode, the LED blinks to indicate that the device has entered into
®
the pairing mode and is ready to be detectable for the first time.
• The LED glows solid blue to indicate that the device is successfully paired.
• The status LED blinks slowly while streaming music in Bluetooth
modes.
3. Mode button:
Press and hold this button to cycle through the available input modes.
4. Previous track/Volume-: Press and hold to decrease the volume level. Briefly
press this button to play the previous track.
5. Next track/Volume+: Press and hold to increase the volume level (when the
maximum level is reached, the speaker will generate a short beep). Briefly
press this button to play the next track.
6. Play and pause/Handset button
In hands-free mode: touch this button to answer and
end a call.
Press and hold if you wish to reject an incoming call.
Press twice to dial the last number called (on supported devices).
In playback mode: press this button to pause your music, or to resume
listening when a call has ended.
In auxiliary mode: it will mute the audio when the pause button is pressed.
7. Aux input jack: Allows the connection of any device equipped with an
auxiliary 3.5mm audio connector (for wired playback). The up and down
volume commands in this mode are enabled.
8. Micro-USB charging port: Charges the built-in battery of the speaker.
and auxiliary
®
9. Power switch: Slide this switch to turn the unit on and off, and to save
battery when not in use.
IV. Basic operation
• Use the supplied USB cable to charge your portable speaker directly from your
computer, laptop or AC adapter.
• Make sure that your portable speaker is fully charged before using it for the
first time.
• The battery has to be initially charged for at least 3 hours. Thereafter, it will
take from 2 to 3 hours to recharge.
• While charging, the LED is solid red. When the battery has reached full
capacity, the red LED goes off.

Publicidad

loading