Orbegozo CP 96160 Manual De Instrucciones página 12

CP 96160
5. Slide the rod down through the pin and insert the wires through the tube.
6. Mount the ceiling bracket using 2 screws and washers.
7, 8. Lift the fan and slide the nylon ball until it covers the base. Make sure that the base hook fits properly
with the groove on the ball. Insert the receiver of the remote control as shown in the picture
9. Connect the power supply wires to the roof support strip according to their polarity: phase-phase,
neutral-neutral and earth-to-earth.
10. Attach the bowl to the ceiling bracket, aligning the side holes and tighten it by tightening the screws
11. Insert the connectors securely. Place the LED plate in the light kit and it will magnetically attach.
12. Install the ceiling lamp into the lamp by turning it clockwise.
OPERATING THE FAN
Select the fan speed by pressing the speed control button on the remote control transmitter :
§
HI: High Speed
Program the fan for 1, 2, 4 or 8 hours by pressing the corresponding button and the fan will stop
§
working after the selected time has elapsed.
Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning on or
§
off of the light.
The motor housing switch varies the direction of rotation of the blades and thus controls the direction of air
movement.
Caution: Before using this direction of rotation switch, turn off the fan and make sure the fan stops rotating
to avoid injury and damage to the motor.
When it's cold: Press the "UP" switch and the blades will direct warm air trapped near the fan down the
entire room.
When it's hot: press the "DOWN" switch and the propeller blades will create a breeze that will spread
throughout the room
MAINTENANCE
TO CHANGE THE LIGHT PLATE
1. Switch the appliance off (it is advisable to also switch off the circuit-breaker or breaker).
2. Remove the plug and remove the LED board.
3. Take a new LED board. Insert the connectors securely. Place the LED plate in the light kit.
4. Reset the power supply and turn on the lamp.
MED : Medium Speed LOW : Low Speed OFF : Off
12