Publicidad
Idiomas disponibles
Idiomas disponibles
Paper Shredder
Sheet Capacity
Operating Instructions
Installation
Paper Shred Size
Operation
Paper Entry Width
Maintenance
Troubleshooting
Credit Card Capacity
Service Center
Duty Cycle
Limited Warranty
Voltage
* ONE FOLDED SHEET OF PAPER EQUATES TO 2 SHEETS OF PAPER
Heavier paper, humidity or other than rated voltage may reduce shredding capacity.
INSTALLATION
1. This model includes a built-in safety interlock mechanism, which requires the shredder to be correctly
mounted on to the included wastebasket. THE SHREDDER WILL NOT OPERATE UNLESS IT IS PROP-
ERLY MOUNTED AS PICTURED. (FIGURE 1)
2. A socket-outlet should be near the equipment and be easily accessible.
3. Connect the power cord to any standard 120 volt AC outlet.
!
Caution:
Microcut shredders have very sharp exposed blades on the underside.
Use care when mounting the shredder on the wastebasket.
FIGURE 1
4
ENGLISH
8 Sheets of 20 lb. bond paper*
0.16 in. x 0.47 in. pieces
4 mm x 12 mm pieces
8.7 in / 220 mm
1 at a time
5 min. on / 30 min. off
120V~60Hz / 3.0 A
OPERATION
Control Switch
Using the switch located on the unit, select one of the following settings by sliding the switch either left
or right. (FIGURE 2)
I
AUTO / ON:
This setting allows the shredder to be automatically started by insert-
ing paper into the feed slot. Always feed the paper in as straight
as possible. When the paper has passed through, the shredder will
automatically stop.
READY: The green LED light indicates the shredder in "On" and
FIGURE 2
O
OFF:
This setting turns off all features of the shredder. For safety reasons,
we recommend that you leave the shredder in the "Off" position
whenever the shredder is unattended or not in use.
R
REV (REVERSE):
In the unlikely event of a paper jam, the reverse setting can be used
to help clear the cutters of paper that did not pass through. Never
attempt to clear a jam by using the reverse function until you have
emptied the wastebasket.
ready for use.
CONTINUED NEXT PAGE
ENGLISH
5
Publicidad
