Geutebruck G-ST 6000+ G3 Manual De Instrucciones página 54

G-ST 6000+ G3
Digital outputs
Assignment of the 25-pin Sub-D sockets
Each unit has four floating digital outputs. Like the digital inputs, these are distrib-
uted onto the 25-pin sub-D socket (relay 1-4).
Using the digital outputs, you can switch external devices, for example, to report sys-
tem errors. The events are created and set up accordingly in the G-Set configuration
software.
The contacts can be soldered directly to the corresponding Sub-D plug. The assign-
ment of the 25-pin Sub-D connectors is shown in the following figure.
Figure: Assignment of the 25-pin Sub-D socket, solder-side
Signal
Connection
13 Normally open contact
25 Normally closed contact
12 Changeover contact
24 Normally open contact
11 Normally closed contact
23 Changeover contact
10 Normally open contact
22 Normally closed contact
9 Changeover contact
21 Normally open contact
8 Normally closed contact
20 Changeover contact
7
Ground
19 Switch input
6 Switch input
18
Ground
5 Switch input
17 Switch input
4
Ground
16 Switch input
3 Switch input
15
Ground
2 Switch input
14 Switch input
1
Ground
Changeover
contact
Socket 1
Relay 4
Relay 3
Relay 2
Relay 1
8
7
6
5
4
3
2
1
22
Back to the
table of contents
Working contact
Break contact
Socket 2
Relay 8
Relay 7
Relay 6
Relay 5
16
15
14
13
12
11
10
9