UGAS 86354 Manual De Instrucciones página 3

Use
1. Unscrew the thread located at the
bottom of the lantern.
2. Insert the gas canister into the thread.
Press the canister up against the metal
pin to pierce the canister and open the
gas supply.
3. Then screw the gas canister securely into
the lantern.
4. Put the decorative stones and metal
mesh in position.
5. Turn the knob and light the lantern with
a lighter.
6. Turn the knob in the opposite direction
to shut off the gas supply and extinguish
the flame.
nB: always leave the gas canister in the
lantern and only remove it when replacing
it.
Warning: If the burner cannot be lit, turn off
the regulator. Wait five minutes before you
try to light it again by following the ignition
procedure.
nB: If the gas canister is screwed on too hard,
you can use pliers to release it again. It is
important not to screw it on using a tool, but
only by hand.
EN
3