Clock Mode; Setting The Clock Time - Coby KCD150 Manual De Instrucciones

Clock Mode

Setting the Clock Time

Make sure the unit has been turned off before setting the
time.
To toggle the clock display between 12-hour mode and
24-hour mode:

Press and hold STOP/CLOCK ADJ [18] for 3 seconds.
The screen will display "12H" for 12-hour mode, or
"24H" for 24-hour mode.

To change modes again, wait until the normal clock
display returns, then press and hold STOP/CLOCK ADJ
[18] again.
The PM indicator will light up in 12-hour mode to
indicate PM hours.
To set the clock time:

Press STOP/CLOCK ADJ [18] once. The screen will
begin to flash.

While the screen is flashing:

Press SKIP UP/HOUR [9] to adjust the hour.

Press SKIP DOWN/MINUTE [10] to adjust the
minutes.

Press STOP/CLOCK ADJ [18] to finish setting the time.
Page 14 Coby Electronics Corporation