Getting Started; Power; Clock Backup; Using Ac Power - Coby KCD150 Manual De Instrucciones

Getting Started

Power

Clock Backup

Open the BATTERY COMPARTMENT [23] and connect one
9-volt battery (not included) to the appropriate terminals.
This backup battery will allow your clock to maintain the
correct time during a power outage or other interruption
of the AC connection.
If the AC connection is interrupted, the clock will con-
tinue to mark the correct time internally. The time
will not be displayed until AC power is reconnected.

Using AC Power

Make sure that the voltage of your electrical power supply
corresponds to the voltage indicated by the manufacturer. If
the voltage is incorrect, consult your dealer or service center.
This unit should be used with AC 120V wall outlets,
only.
Connect the electrical cord by plugging it into the wall
outlet. Keep objects clear of the cord where it connects to
the device and to the wall. Do not stretch the cord.

To turn on the unit, press POWER/ALARM OFF [13].
The POWER ON INDICATOR [4] will light up.

To turn off the unit, press POWER/ALARM OFF [13]
again. The POWER ON INDICATOR [4] will darken.
Page 8 Coby Electronics Corporation