Control Panel View - Ducasa M-28 SPLIT Manual Del Usuario

start,the rules same as 4) THERMOSTAT INSTRUCTIONS,pls noted.
You can set different open time ,closed time and temperature within whole week.
6) Window Open Function
1.Open the appliance as working conditions,(fan,warm,hot are all ok).This function only
through by Remote control.
2.Press " " button, the "
energy models.(In this function,the appliance is check and record environment temperature
in immediately.It will stop working,when the appliance check the environment are drop ≧3
minute.The user should restart the appliance with "ON/OFF" button)
℃
within 1
3..Press " " button again, the "
7)This function can be use should be fit two points :
1. the appliance is in the standby state.
2. before the appliance working.
This function only through by Remote control.
PS:Press " " button,screen shows number will twinkle 3 seconds,you should operate in
time ,otherwise appliance will get back to standby, you need press "
the appliance and reset again all.
(This function is one-time and must be reset if the power is cut off.)
8)Child-Lock Function
1. This function only through by Remote control.When appliance are plug in,this function
can be used in any models.
2. Press " " button one time, all lights and LED display are closed ,only "Power" light
on.In this condition, either control panel or remote control can not operate the appliance for
any function.
3. Press " " button again, all lights are on and both control panel and remote control are
use to succeed.

CONTROL PANEL VIEW:

" light is on.The appliance is working as smart saving
" light is off.Window Open Function is closed.
17
" button to awaken