Glacier bay HDQFW6AC027CP Guía De Instalación Y Cuidado página 4

Installation
1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Remove pre-assembled lock nut (H), metal
spacer (G), and rubber spacer (F) from shank of
faucet body (J).
□
Place the faucet (J) through the mounting holes
in the sink.
□
Ensure the slot openings of the rubber spacer
(F) and metal spacer (G) face toward the rear of
the sink.
□
Secure the faucet (J) to the sink using the lock
nut (H) provided.
J
F
G
H
J
F
G
H
H
2
Installing the faucet handles
□
Remove the preassembled guide washers (E),
metal washers (D) and rubber washers (C) from
the hot and cold faucet handles (A and K).
□
Loosen the screws on the guide washers (E) until
the ends of the screws are flush with the face of
the guide washers (E).
□
Insert the hot faucet handle (A) to the left of the
spout and cold faucet handle (K) to the right of
the spout.
□
Attach the faucet handles (A and K) underneath
the sink using the rubber washers (C), metal
washers (D) and guide washers (E). Securely
tighten the screws on the guide washers (E).
A
A
C
D
4
E
K
E
E
K