Preparation Before Operation - Mitsubishi Electric Mr.SLIM MSZ-FE09NA Manual De Instrucciones

P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
Be sure to set the installation position before installing the batteries.
4.
Press RESET
1.
Remove the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Setting current time
1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin instrument.
Changing temperature units (ºF→ºC)
Unit is preset with ºF.
1.
Press RESET while
the temperature but-
tons are pressed.
• Press RESET gently using a thin instrument.
• To change temperature unit from ºC to °F, press RESET.
Page 5
2.
Insert AAA
alkaline batteries
3.
Install the front lid
2.
Press the TIME buttons to set
the time
Each press increases/decreases
the time by 1 minute (10 min-
utes when pressed longer)
En-4