Linea 2000 DOMO DO7057S Manual De Instrucciones página 21

Idiomas disponibles

While steaming, it is normal to hear the water being pumped. This can also be felt in the handle.

To remove wrinkles, press the steam plate against the material while steaming. Move the clothing

steamer over the material. Do be careful not to continue to steam the same location for too long.

CAUTION: always be careful when using the steamer. The appliance and the steam are hot. Never aim

steam at people.

After use, turn the appliance off by holding down the on/off button for a few seconds. The indicator

light will go off. Remove the plug from the socket.

Allow the appliance to cool completely. Remove the water from the reservoir and store the appliance.

If the appliance is not used for 15 minutes, it will enter standby mode. The on/off button's indicator

light will flash red. If you want to reactivate the appliance, press the steam button or the on/off button

and wait until the appliance has warmed up again.

FILL THE WATER RESERVOIR

Press and hold the water reservoir release button and remove the reservoir from the appliance by

pulling it towards you.

Click open the filling opening. Fill the reservoir with water, making sure not to exceed the maximum

level. Use only mains water or 50 % mains water and 50 % de-mineralised water. Do not use

perfumed water. Click the filling opening closed again.

Replace the water reservoir in the appliance; you will hear a click.

To fill the water reservoir during use, turn the appliance off with the on/off button. Remove the plug

from the socket and follow the instructions above.

BRUSH HEAD

The brush head can be used for thicker materials, furniture or removing hairs.

Attach the brush head when the appliance is cool.

Place the top of the brush head on the top of the appliance. Then fasten the bottom with a click.

Always allow the appliance to cool completely before removing the brush head.

Remove the brush head by lifting the lid on the top.

www.domo-elektro.be

DO7057S