Polar CH479 Manual De Instrucciones página 4

EN
but also combustible. When
transporting and installing,
ensure that no parts of
refrigerating circuit are
damaged. Refrigerant leaked
from the refrigerating pipes
could ignite. If leaking is
detected, to avoid any
potential source of ignition
(spark, naked flames, etc.),
please open window or door,
and keep good ventilation.
• Do not store explosive
substances such as aerosol
cans with a flammable
propellant in this appliance.
Warning: Keep all
ventilation openings clear
of obstruction. Unit should
not be boxed in without
adequate ventilation.
• Warning: Do not use
mechanical devices or other
means to accelerate the
defrosting process, other
than those recommended by
the manufacturer.
• Warning: Do not damage
the refrigerant circuit.
• Warning: Do not use
electrical appliances inside the
food storage compartments
of the appliance.
4
CH479_ML_A5_v1_20230419.indb 4 CH479_ML_A5_v1_20230419.indb 4
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.
The ice maker is designed to make ice and
should not be used as storage to preserve
foods, drinks, etc.
Pack Contents
The following is included:
• Ice Maker
• Removable ice basket
• Ice scoop
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
3. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
2023/4/19 14:17 2023/4/19 14:17