Publicidad
Idiomas disponibles
Idiomas disponibles
ZAF
Initial Operation (picture
)
1. Initially switch the units on and off for a few seconds to check the direction of rotation against the direction arrow.
Note: On this initial start the pipework should not be connected.
2. Connect the suction and pressure pipes.
Assign the hoses of the printing press corresponding to the numbering on the hoses inside the connection plate (X).
Potential risks for operating personnel
Noise Emission: The worst noise levels considering direction and intensity measured according to DIN 45635 part 3 (as per 3. GSGV) are shown
in the table at the back. When working permanently in the near vicinity of the AIR-CENTER we recommend wearing ear protection to avoid any
damage to hearing.
Maintenance and Servicing
When maintaining these units and having such situations where personnel could be hurt by moving parts or by live electrical parts,
the AIR-CENTER must be isolated by totally disconnecting the electrical supply. It is imperative that the unit can not be re-started
during the maintenance operation.
Do not maintain a component that is at its normal operating temperature as there is a danger from hot parts.
For maintenance of the individual components see corresponding operating instructions:
SAP 180 + SAP 300
KTA 80 /1 + KTA 100 /1 + KTA 140 /1
KTA 80 /4 + KTA 100 /4
For lubrication, checking and changing blades on the KTA, the side panel (T
maintenance the doors (T) must be opened (see picture
1. Filters (ZAF) (picture
)
The suction filter (ZAF) should be cleaned every 250 operating hours and changed every 3000 operating hours. Changing the filter: unscrew
wing nut (m
). Remove filter cover (h) and filter cartridge (f
1
air. Replace the filter cartridge if necessary. Re-assemble in reverse order.
2. Cooling (pictures
and
The space between the air slots of the AIR-CENTER may become blocked by dust. They must be checked and cleaned reguarly, by blowing
out the slots of cooling air entry (E) and cooling air exit (F) with compressed air.
Trouble Shooting
see enclosed operating instructions
Appendix:
Repair on Site: For all repairs on site an electrician must disconnect the motor so that an accidental start of the unit cannot happen.
All engineers are recommended to consult the original manufacturer or one of the subsidiaries, agents or service agents. The address of the nearest
repair workshop can be obtained from the manufacturer on application.
After a repair or before re-installation follow the instructions as shown under the headings "Installation and Initial Operation".
Lifting and Transport: To lift and transport the AIR-CENTER the eye bolt on the box must be used. The cooling grills at the base should be removed
when the AIR-CENTER is to be transported by fork lift or two hydraulic hand lifts.
All doors must be closed during transportation.
The weight of the AIR-CENTER is shown in the accompanying table.
Storage: The AIR-CENTER must be stored in dry ambient conditions with normal humidity. We recommend for a relative humidity of over 80%,
that the appropriate drying agents are put in and it is made airtight.
Disposal: The wearing parts (as listed in the spare parts lists) should be disposed of with due regard to health and safety regulations.
Spare parts lists:
Box: on request
Components: see enclosed operating instructions
BE 545
BE 450
BE 458
).
). The filter cartridge can be cleaned by knocking out by hand or by using compressed
1
)
f
h
1
) of the AIR-CENTER must be removed (see picture
2
m
1
). For all other
11.2000
/ PM6
Publicidad
