Makita AN902 Manual De Instrucciones página 6

coil is set properly in the magazine.
Connecting air hose
010583
Slip the air socket of the air hose onto the air fitting on
the nailer. Be sure that the air socket locks firmly into
position when installed onto the air fitting. A hose
coupling must be installed on or near the tool in such a
way that the pressure reservoir will discharge at the time
the air supply coupling is disconnected.
OPERATION
CAUTION:
Make sure all safety systems are in working order
•
before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
2
014423
014424
2. Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you
•
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
1. Air fitting
1
2. Air socket
2
1. Trigger
2. Contact arm
CAUTION:
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
For squential trip trigger (accessory)
1
2
012338
Rotate the lever to the
button on the other side of the lever.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger.
CAUTION:
WITH THE TRIGGER HELD IN A HALF-PULLED
•
POSITION, an unexpected nailing could occur, if
contact element is allowed to re-contact against
the workpiece or the other surface under the
influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
− A. Do not place the contact element against the
workpiece with excessive force.
− B. Pull the trigger fully and hold it on for 1-2
seconds after nailing.
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
Jammed nailer
012341
CAUTION:
Always disconnect the air hose and remove the
•
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert
a small rod or the like into the ejection port and tap it with
a hammer to drive out the nail jamming from the ejection
port. Reset the nail coil and close the magazine cap.
6
1. Trigger
2. Lever
position while pressing the
1. Hammer
1
2. Small rod
2