Descargar Imprimir esta página

STACK-ON E-8-MB-E-S Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

ENTERING YOUR SECURITY CODE
To enter your own security code you will need to
follow the steps listed below:
1. A er opening the electronic safe (with the preset
factory code of 1 - 5 - 9 - #) locate the small red
bu on on the inside of the door near the hinge.
2. Press the red bu on and then release it, you will
hear a beep.
e yellow light on the faceplate will be
activated and will stay on for a period of time that
should allow you to enter your code. You can only
enter your code while the yellow light is on.
With the door open and the yellow light on, enter
your own personal security code, which can be 3 - 8
digits long, and con rm your new code by pressing
the "
" symbol on the electronic touch pad.
Before you close the door, try the new security code
to make sure the lock releases the handle so you can
turn it and retract the live action bolts.
DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR NEW
SECURITY CODE HAS BEEN ENTERED
CORRECTLY.
If the code fails, go through steps 1 and 2 again. If
the code works successfully record your
combination number on the front of this form or
store your combination on our secure website at
www.stack-on.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from children,
not inside the safe.
the safe.
When you open the safe in the future enter the
security code you have set followed by the " # "
symbol.
If the incorrect security code is entered 3 times you
will have an automatic lockout for 20 seconds before
you can try your code again.
If the incorrect security code is entered 3 additional
times there will be a 5-minute lockout before the
code can be tried again.
en you should close and lock
LOCKING THE SAFE
To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds a er the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe.
TURNING THE KEYPAD SOUND OFF/ON
You can turn o the "Beep" sound of the keypad by
entering the code
6 3 3.
To turn the "Beep" sound on, enter the code
SELECTING A LOCATION
e safe must be mounted to the oor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
e safe should be at against the wall and oor.
Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
6 6.
3
40529-1504
24

Publicidad

loading

Este manual también es adecuado para:

E-13-mb-e-s