Publicidad
Idiomas disponibles
Idiomas disponibles
Plug the power cord into the nearest outlet. Make sure the surface is dry (never place
Airfree
on wet floor or immerge it in water). Make sure the On/Off led is on. Adjust
®
the Night Light intensity with the touch sensor. After 30 minutes the top lid should be
warm.*
Place Airfree
on a flat surface, not under furniture, shelves, or behind curtains as it
®
will interfere with airflow and Airfree
Check if the area is compatible with the unit capacity to achieve best unit performance.
Using Airfree
in rooms larger than its capacity will greatly reduce its purifying
®
capacity.
Airfree
must be continuously on in the same room, 24 hours a day. Nevertheless,
®
temporarily removing it from the room will allow new microorganism contamination to
grow but it will be destroyed when Airfree
without Airfree
the higher the new contamination in the room.
®
Rooms with air condition or ventilation will not affect the air sterilization efficiency of
your Airfree
. Same for Heating systems.
®
Airfree
can be placed in corridors but the air sterilization effects will barely have any
®
effect in connecting rooms.
Avoid place the unit near open doors or windows to prevent some of the sterilized air
to exit the room.
SHORT POWER CORD INSTRUCTIONS
- A short power supply cord is provided to reduce the risk resulting from becoming
entangled in or tripping over a longer cord.
- Extension cords are available and may be used if care is exercised in their use.
- If an extension cord is used, the marked electrical rating of the extension cord should
be at least as great as electrical rating of the appliance, and the longer cord should
be arranged so that it will not drape over the counter or table top where it could be
pulled on by children or tripped over unintentionally.
POLARIZATION INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug will fit in a polarized outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not modify the plug in any way
To turn the fan ON or OFF, press and hold the sensor touch button for at least 6
seconds. Top light - Press the same sensor touch button multiple times to achieve the
desired light brightness or to turn it off completely.
For faster air sterilisation select the boost mode. This function will turn on the
fan on 4 different speed options to increase the air flow, usually for 1/2 hour or
1 hour.
Installing and Connecting
efficiency in destroying microorganisms.
®
®
5 5
is plugged in again. The longer the period
Publicidad
