Duronic STM11 Manual De Instrucciones página 12

6. Unwind the power cable(3) from the
cable management hooks(2).
A quick way to release the cable is to
rotate the cable management hooks
inwards as this automatically releases
the whole cable at the same time.
7. Plug in the power cable to a mains outlet.
On the mop main unit, press the power
button(8).
The power indicator light will light up red
and the unit will start to preheat.
8. When the preheating is done, the light
will turn green.
The water pump will start working and
you will start to see steam start to come
out of the mop head(9).
9. Push and glide the mop over the floor
surface to clean it. Try to use up all the
water in the tank at one time.
Do not use the mop just in one place, or
on the same place over and over again.
Depending on the material of the floor, it
may deform or fade it over time.
If there is any water left in the water tank,
empty the remaining.
12
2
3
8
9