ENGLISH
Overview
A - Charging contacts
B - Proximity sensor
C - Microphone
Charging
It is recommended that the earbuds and charging case be fully charged before rst use.
To charge the earbuds, place them in the charging case and close the lid. If the charging case is not
connected to a power source, the charging case status LED will show which earbuds are charging.
CHARGING CASE STATUS LED
To charge the charging case, connect a power source to the USB-C port on the bottom of the case. The
charging case status LED will ash the current battery level. The LED will then breath to indicate the
charging status until turning solid, indicating a full charge.
CHARGING CASE STATUS LED
Solid Green
Breathing Green
Breathing White
Breathing Red
Once fully charged, if the charging case's lid is opened or the button is pushed, the LED will turn o .
Powering on and o the Earbuds
To power on the earbuds, open the charging case. The earbuds will power on and the charging case
status LED will ash to indicate the battery level of the charging case. The earbuds can also be powered
on outside of the case by holding the touch sensors for 3 seconds.
To power o the earbuds, return them to the charging case and close the lid. The earbuds will power o
and the charging case status LED will indicate which earbuds are charging. The earbuds can also be
powered o outside of the case by holding the touch sensors for 8 seconds.
Pairing the Earbuds
1. Power on the earbuds. The earbuds will automatically attempt to reconnect to their last Bluetooth®
enabled device(s).
2. The earbuds will automatically enter pairing mode anytime they are not connected to a Bluetooth®
device. To enter pairing mode while connected to a Bluetooth® device, use the device's settings to
D - Touch sensor
E - Charging case
F - Charging case button
Yellow
Purple
Cyan
G - Charging case status LED
H - USB-C port
I - Ear tips (large, small)
J - USB-C to USB-A cable
EARBUD S CHARGING
Left
Right
Left & Right
CHARGING CASE BATTERY LEVEL
100 %
71 % - 99 %
30 % - 70 %
< 30 %