STEINEL GluePRO 300 Manual De Instrucciones página 12

Operation/Function
Startup
L Plug the tool in.
L Switch the tool ON by pressing the ON/OFF but-
ton for two seconds. The tool immediately heats
up to the selected temperature.
L While it is heating up, the LED flashes red /
the display lights up blue.
L Once the LED shows red / the display lights up
green, the temperature setting range has been
reached and the hot-melt glue applicator is ready
for use.
L If the temperature range is too high, the LED /
display lights up red.
L Insert the hot-melt glue stick into the opening at
the rear of the tool.
L Switch the tool OFF by briefly pressing the ON/
OFF button.
Temperature setting
GlueMatic 7011
L The temperature can be selected to an accuracy
of one degree from 40 to 230 degrees Celsius. On
leaving the factory, the tool is set to 190 degrees
Celsius.
L Press the SET button
pressed, select the chosen temperature via the
7 8
+ UP and DOWN buttons. The tempera-
ture you select is shown on the display.
6
L Releasing the
SET button shows you the tem-
perature now reached in the heating chamber.
L Keep the SET button pressed. Pressing the UP or
DOWN button automatically increases or reduces
temperature in steps of 1 degree. Keeping the UP
or DOWN button pressed for at least 3 seconds in-
creases or reduces temperature by 5 degrees.
L
Do not select any temperature higher than is
needed for applying the hot-melt adhesive!
Other functions of GlueMatic 7011
Other functions of GlueMatic 7011
LOC function
To avoid altering the chosen settings unintentionally,
the GlueMatic 7011 comes with the Lockable Over-
ride Control function (LOC). To find out how to set
the LOC function, contact our Service Department on
05245 448 188.
6
. Keeping the SET button
Stroke adjustment
L Glue feed can be adjusted to suit any particular
application, giving you precision in selecting an ex-
act quantity of glue per stroke and letting you set
the feed trigger
L The slide control for adjusting glue feed
12
the trigger to reduce or increase the quantity of
glue delivered.
L Pull the trigger and move the glue feed slide con-
3
trol towards the nozzle until the tool delivers
the chosen quantity of glue per trigger pull or gives
you the delivery rate you find easy to work with.
L Adjust the slide control in the opposite direction to
restore the initial position.
Changing nozzles
Customised nozzles are available for specific applica-
tions. To change the nozzle, the tool must be warm
and unplugged. For this, heat up the GluePRO 300
for no more than 45 seconds.
Heat the GlueMatic 7011 to no more than 100
degrees Celsius.
Switch the tool OFF once it has reached temperature.
1. Hold the tool with heat-protective gloves.
2. Unscrew nozzle
At this point, never pull the trigger!
3. Screw the replacement nozzle on hand-tight.
Idle mode
After any selectable period, idle mode automatically
reduces the temperature in the heating element to a
temperature you can select. This depends on when
the button was last pressed. Idle state is indicated by
the blue flashing LED / blue flashing display. On leav-
ing the factory, this function is deactivated. To find
out how to set idle mode, contact our Service Depart-
ment on 05245 448 188.
- 12 -
12
for ease of use.
13
.
3
adjusts