Publicidad
Idiomas disponibles
Idiomas disponibles
Now you can begin to dry ironing.
HOW TO USE THE SPRAY
Before using the spray feature, check the fabric label for ironing instructions because
some fabrics may be spotted or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed. The spray may be use with steam or dry ironing. Simply pump the
spray mist knob when desired.
HOW TO USE AS STEAM IRON
Fill the iron with water.
1. Position the iron vertically and turn the temperature control dial to the steam po-
sition.
2. Plug the cord into the electrical outlet.
3. Set the temperature control dial to the steam position. Steam ironing is only pos-
sible at higher temperature settings indicated with the "MAX" mark, otherwise the
water will leak from the soleplate.
4. Preheat the iron until the indicator light goes out. The light will turn off when the
indicated setting reaches the correct temperature.
5. Turn the variable steam control knob to the required setting for different types of
fabric.
Now you can begin steam ironing.
HOW TO USE THE BURST OF STEAM
The burst of steam feature provides additional steam for removing stubbom wrinkles. It
may be used with steam or dry ironing.
Press the power steam button to release the surge of steam. Pressing the button several
times may be necessary to prime the surge system. Wait a few seconds for the steam to
penetrate the fabric before pressing the button again for more steam.
Note:
For optimum steam quality, do not apply more than three successive shots after the
indicator light goes off.
ANTI-CALC FUNCTION
The anti-calc function is a permanet system located inside the water tank to eliminate im-
purities from the water and to reduce the problems connected with limescale build-up.
To prolong the efficiency of this system, follow these steps occasionally:
Publicidad
